03 taurus unlocking

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=110137
Printed Date: July 18, 2025 at 5:38 AM

Topic: 03 taurus unlocking

Posted By: saleen49
Subject: 03 taurus unlocking
Date Posted: December 28, 2008 at 8:41 PM

Today I installed a crimestopper remote start/keyless entry, on my moms car, as a Christmas gift. I hooked the green and blue door triggers to pink/green, pink / YELLOW just below the factory GEM module. After remote starting, the doors lock and then immediately unlock . Do I need to diode the wires? The car has factory keyless entry.

Thanks

Replies:

Posted By: ziggyb222
Date Posted: December 29, 2008 at 6:19 AM

Was the drivers door open when you tried it?

Posted By: Mike M2
Date Posted: December 29, 2008 at 6:37 AM

The Taurus always unlocks the drivers door after locking if the door is open. It could be the RS locks the doors when the RS is turned on(the Idatalink units do this too).

-------------
Mike M2
Tech Manager
CS Dealer Services

Posted By: saleen49
Date Posted: December 29, 2008 at 9:53 AM

Yes, the drivers door was open. I thought it also did it with the door closed. It was not just the drivers lock that popped open, they all did it. I was under the impression that diodes were needed for this setup.

I will be finishing it today and will post back.

Thank you for the relpys,

Frank

Posted By: saleen49
Date Posted: December 29, 2008 at 6:32 PM

I finished the install today. The doors only unlock while the drivers door is open. I feel better knowing that this is normal on this car.

Thanks for the info;

Frank

Print Page | Close Window