programming a new remote to a code alarm

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=110175
Printed Date: April 29, 2024 at 5:07 PM

Topic: programming a new remote to a code alarm

Posted By: Fosgate3
Subject: programming a new remote to a code alarm
Date Posted: December 30, 2008 at 7:58 AM

I have a Code Alarm, CA-670 and my LCD remote got wet and died. I have a replacement remote but I can't find instructions in the manuals for reprogramming it. Can anyone assist?

-------------
i think a wire's loose somewhere...

Replies:

Posted By: advanced
Date Posted: December 30, 2008 at 10:04 AM

This should help you.

https://www.the12volt.com/installbay/downloads.asp?srch=all&term=670

-------------
Good Enough Isn't!

Posted By: Fosgate3
Date Posted: December 30, 2008 at 11:01 AM

I called Code. I may have overlooked it but I couldn't find it in the manuals. I looked there first. The Code support person advised to keep the driver's door open, turn the key to "on", press and hold the valet for 15secs until the alarm chirps 3 times. It's supposed to be in "learning mode" at that point. Press the lock button of the new LCD remote and it will chirp once. That's the deal. Thanks for the links to the manuals though.

-------------
i think a wire's loose somewhere...

Posted By: advanced
Date Posted: December 30, 2008 at 3:48 PM

The transmitter programming procedure is on the top of page 8 of the Install Guide, on that link that I gave you.

You got it done - that's what counts.

-------------
Good Enough Isn't!

Print Page | Close Window