Print Page | Close Window

autopage rs 622 lcd won’t start?

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=110176
Printed Date: May 16, 2024 at 8:26 AM

Topic: autopage rs 622 lcd won’t start?

Posted By: snake07
Subject: autopage rs 622 lcd won’t start?
Date Posted: December 30, 2008 at 9:21 AM

Hi all,

I installed the Autppage RS 622 remote starter on 05 toyota high lander and it wouldn't remote start when I press the start button on the remote.

When I press the lock and unlock button, I can hear the relay clicking and also see the output from the lock/unlock wire live, but when I press the remote start button, I did hear the relay clicking and no output from the starter wire output.

I just wondering if it this issue has to do anything with the "safey remote start wire", basically this module has a "safety remote start wire output" , this wire supposed to be (-) when the car is parking. I was lazy tried to find the wire the parking wire so I connected to chassis ground.

Thank you for all inputs,

Replies:

Posted By: snake07
Date Posted: December 30, 2008 at 9:23 AM

I should have said "when I press the remote start button, I did not hear the relay clicking and no output from the starter wire output "

Posted By: advanced
Date Posted: December 30, 2008 at 9:52 AM

I don't want to be the internet police, but you should keep your thread going under the same topic. It's not necessary to start a new topic.

-------------
Good Enough Isn't!

Print Page | Close Window