astroflex model 800
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=110185
Printed Date: May 16, 2024 at 4:08 AM
Topic: astroflex model 800
Posted By: mauri197
Subject: astroflex model 800
Date Posted: December 30, 2008 at 2:55 PM
hey guys i have an astrostart model 800 that is doing nothing evrytime i hit the remote for it to start the led flashes the module sees the remote but no ignition no crank nothing and it doesnt send any flashes after that to try to figure out tanx its on a s10 pick up 2000 no power lock no windows tanx
Replies:
Posted By: moonliter
Date Posted: December 30, 2008 at 3:45 PM
Count the number of led flashes after it fails to start. Most likely problems are : x = number of flashes on the module - 4x no tach signal
- 5x hood open
- 8x switch is in OFF
Posted By: mauri197
Date Posted: December 30, 2008 at 3:50 PM
the led does not flash after i it the remote
Posted By: moonliter
Date Posted: December 30, 2008 at 4:13 PM
Well in that case, check for +12 volts at the module, make sure the ground & antenna is properly connected. After that, try to reprogram the remote. dip sw 8 up, hit the brake once, press any button on the remote, dip sw down & hit the brake once more. Try to remote to see if it works.
Posted By: mauri197
Date Posted: December 30, 2008 at 4:18 PM
tanx for the quick reponse but the remote programs i have a good ground and 12 volts going to it but it doesnt do nothing the led flashes when i hit the remote but it wont remote start and after that the led doe not flash
Posted By: moonliter
Date Posted: December 30, 2008 at 5:40 PM
Another thing I can think of, it has dc volt presented at the ign wire. It could be caused by a backfeed or a faulty ign switch. You might want to check it with a dmm.
Posted By: mauri197
Date Posted: December 30, 2008 at 5:59 PM
i just checked the ignition wire there is no feedback coming from the switch its really getting to me already
Posted By: mauri197
Date Posted: December 30, 2008 at 6:07 PM
is there a way to reset the system to where you have to reprogram tach and set it for automatic
Posted By: moonliter
Date Posted: December 30, 2008 at 6:14 PM
Is this a new installation or it just quits working ?
Posted By: mauri197
Date Posted: December 30, 2008 at 6:16 PM
Posted By: moonliter
Date Posted: December 30, 2008 at 6:30 PM
see install manual astroflex 800 for how to progtam tach
Posted By: mauri197
Date Posted: December 30, 2008 at 7:08 PM
tnx
|