h1 red/white 200ma, 1000esp python alarm

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=110276
Printed Date: May 16, 2025 at 1:55 AM

Topic: h1 red/white 200ma, 1000esp python alarm

Posted By: eg_h22
Subject: h1 red/white 200ma, 1000esp python alarm
Date Posted: January 02, 2009 at 11:31 PM

Hello ALL, I have a question regarding the "H1 RED / white 200mA channel 2 validity output". The alarm is a 1000esp python alarm. This is my first attempt on installation to my own car. Everything on the install so far went fairly smooth, but I accidentally wire the "H1 RED / white 200mA" to a positive source and now it doesn't work. Has anyone ever went through the same situation and is there a fix to this? THANKS, Chris.

-------------
what dogg?

Replies:

Posted By: i am an idiot
Date Posted: January 03, 2009 at 7:10 AM

I am not familiar with that particular alarm module, but if you can take the module apart, and follow the traces on the board from the pin that connects to the wire. If it goes directly to a transistor, you should be able to easily repair the unit. On the other hand, if it goes to an Integrated Circuit, it can still be repaired, just a little more difficult.. If you trace it back to either of the 2, post the numbers on the part and I can locate one and assist you in the repair.

Print Page | Close Window