I am almost finished installing a remote starter in my brother in-laws 07 Dodge Ram. Only thing I have left to do is the parking lights.
I have read numerous posts saying it must be triggered via a relay and 1130ohm resistor. I have no knowledge of relays.... so please help me out.
Do I need a 4 prong relay or a 5 prong relay??
Most of all -- How do I wire the relay?
Your help is greatly appreciated.
t&t tech wrote:
what type of trigger are the parking lights, negative or positive
Sorry.... they are NEGATIVE -- 1130 ohms
I forgot to mention my Remote starter has the option for a pos (+) or (-) neg parking light output also. If i just use the (-) neg output.... could I just wire the 1130 ohm resistor to it and directly connect to the vehicles parking light wire??
OK....
If that does working correctly.... can you please still post how I would hook up the relay using the positive parking light output from the remote starter?
Thanks
here it is

-------------
COMMIT YOUR WAY TO JEHOVAH AND HE WILL ACT IN YOUR BEHALF.
PSALMS 37:5
huh? i just use the positive trigger output from the alarm and pick up the WHITE/ yellow and WHITE/ gray wires in the driver kick panel and diode isolate. no relay, no resistor needed.
you have individual possitive wires one for each side fine the two wires and then go to radio shack and buy 2 3 or 6 amp diodes
twist the no stripped side of both diodes together then connect the positive wire from rs system to the twisted side of the diodes. then take the other two ends of the diodes and connect one to each vehicle parking light wire then your done and the two light wires are still isolated from each other.
or you can go the negative route
at the swtich find the WHITE/ lt. green wire and about 3 inches from swich cut it.
then take a relay and connect the switch side of cut wire to pin 87a center pin
connect the other side of the cut wire to pin 30
pin 85 connect to possitive output from remote start system.
pin 86 ground
pin 87 place your 1130 ohm reistor between pin 87 and pin 86 this will be the resisted ground output you need. your done.
-------------
Jon
Installer/Help Technician
---coral springs florida---
mecp certification is not always needed. I have it and it has not helped me out at all. my experience out shines it.
[QUOTE=stiver_32]I forgot to mention my Remote starter has the option for a pos (+) or (-) neg parking light output also. If i just use the (-) neg output.... could I just wire the 1130 ohm resistor to it and directly connect to the vehicles parking light wire?
i made a mistake, if ur gonna do the negative parking lights you'll need a relay, as the on baoard circuit will already have resistors inserting another in line between alarm and car wire will give a resistance higher than required and not turn on ur lights, orr ou can go the positive trigger way like those guys mentioned above,
-------------
COMMIT YOUR WAY TO JEHOVAH AND HE WILL ACT IN YOUR BEHALF.
PSALMS 37:5