remote start bypass, 03 chrysler 300m?

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=110357
Printed Date: May 15, 2024 at 11:18 AM

Topic: remote start bypass, 03 chrysler 300m?

Posted By: focuszx3lover
Subject: remote start bypass, 03 chrysler 300m?
Date Posted: January 05, 2009 at 8:05 AM

I have a 03 Chrysler 300M and am trying to hook up a remote start with alarm "Prestige". I am using a bypasskit data bus CHDL2 PK, and for some reason its not reading the transponder bypass portion. Does anyone have any ideas, I have went step by step on how to program it and everything went right word for word off instructions but still no luck. I even went and purchased a universal bypass and using a key and it's still not working All the extras work ie. doorlocks,dome light illumination,trunk,parking lights,windows down, alarm. Any ideas would be appreciated

Thanks Brandon

Replies:

Posted By: xplorin16
Date Posted: January 05, 2009 at 10:00 AM

If you used a universal and a key and its still not working then its not the bypass thats your issue. When you say its not working, does try to crank? Does it crank at all? does the security light flash?

-------------
Advanced MECP

Posted By: focuszx3lover
Date Posted: January 05, 2009 at 1:13 PM

nothing no crank nothing just relays clicking inside the r/s module checked connections and all have required power and correct polarity tach wire is hooked up to (-) of coil they don't need a third ign. relay but what about a starter interupt. I believe they do i have the wiring diagrams and all off of alldata and wire codes off of Tech Systems/Code services security light doesn't flash

Posted By: tedmond
Date Posted: January 05, 2009 at 4:09 PM

does parking lights flash at all, if they do see waht diagnostics it shows up as. i suggest you verify your wires

WIRE		COLOR		POLARITY		LOCATION
	Battery		PINK/BLACK OR RED		(+)		IGNITION SWITCH HARNESS
	Ignition 1		DARK BLUE/WHITE		(+)		IGNITION SWITCH HARNESS
	Ignition 2		GREEN/ RED		(+)		IGNITION SWITCH HARNESS
	Accessory 1		BLACK/ ORANGE		(+)		IGNITION SWITCH HARNESS
	Starter 1		YELLOW		(+)		IGNITION SWITCH HARNESS

Posted By: focuszx3lover
Date Posted: January 05, 2009 at 4:30 PM

parking lights don't flash called tech support and they say its a bad module tried three different locations for tach signal and then went tach less and still nothing So sending the module back thanks guys

Posted By: bluest4
Date Posted: January 05, 2009 at 5:14 PM

Did you check the BLACK/ white wire. This wire is a what Audiovox calls the control safety switch. It is normal hooked up to ground with the switch that came in the box. If this wire doesn't see ground the car will not even attempt to start. Also check the gray wire at the brain (if you hooked it up) it is the hood pin and if it sees negitive (hood up) the car won't attempt to start.

Steve