pc programming python 1500 esp

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=110462
Printed Date: July 15, 2025 at 1:16 AM

Topic: pc programming python 1500 esp

Posted By: exfsiguy1
Subject: pc programming python 1500 esp
Date Posted: January 08, 2009 at 1:15 PM

Hello all,

I have a working Python 1500 ESP that is going to be utilized in a different application from the original install. The documentation says that the 3 pin connector supports either a Bitwriter(?) or PC communications. Anyone have any experience in the PC connection?

Do you need some form of "dongle"?

Is it just Tx, Rx, and ground? If so which pins are which?

Do you use hyperterminal?

Any input/help is appreciated.

Thanks again,

Terry

-------------
exfsiguy1

Replies:

Posted By: exfsiguy1
Date Posted: January 08, 2009 at 1:17 PM

Oops,

Also (if applicable) baud rate, parity, etc

Terry

-------------
exfsiguy1

Posted By: loneranger
Date Posted: January 09, 2009 at 12:04 AM

This is actually a module converting the protocol from the PC RS-232 interface to the protocol on the ESD RS-232 interface. I haven't seen it and it been discontinued for awhile now. It does require an application on the PC.

Posted By: exfsiguy1
Date Posted: January 09, 2009 at 9:52 AM

Hello,

Thanks for the quick response. I didn't think it sounded easy or viable, considering the lack of info available. I was just being lazy, wanting to use tools to make a job easier.

Great site by the way, and I'll be posting whenever possible.

Thanks again,

Terry

-------------
exfsiguy1

Print Page | Close Window