pkucg2x bypass for cobalt
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=110480
Printed Date: May 10, 2025 at 6:20 PM
Topic: pkucg2x bypass for cobalt
Posted By: skablamm
Subject: pkucg2x bypass for cobalt
Date Posted: January 08, 2009 at 10:49 PM
I just wanted to see if anyone has installed this bypass in a Cobalt (07) install instructions have a diagram were it shows the starter wire from the Remote start going to the starter wire of the car with 9.6K resistor inline. What is with this? does that not apply for the cobalt? Do I have the right Bypass? Cobalt has no starter wire. Does it not start when it sees voltage on the ignition?
Replies:
Posted By: chadwa2003
Date Posted: January 09, 2009 at 8:00 AM
Get the ads-al-ca from idatalink its alot easier and all the wiring is done on the passenger side below the radio. It will do locks, trunk, tach, door, hood, and trunk status as well. Very good bypass also if you install it with a unit that has rs 232 then you have minimal connections
|