2006 f250 domelight supervision

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=110565
Printed Date: May 16, 2024 at 6:34 AM

Topic: 2006 f250 domelight supervision

Posted By: jpinusmc
Subject: 2006 f250 domelight supervision
Date Posted: January 11, 2009 at 5:14 PM

All,

I just installed an autopage rs-1000 in an 06 f-250 super duty. I used a wiring diagram that instructs to use the domelight supervision wire for the door trigger. This works except that whenever the remote start turns off the alarm sounds. I am guessing this is because when you turn off the truck, the lights come on inside.

Is there a better way to wire this/ a way to disable the dome supervision in the truck?

Thanks for the help.

Replies:

Posted By: ckeeler
Date Posted: January 12, 2009 at 12:55 PM

do not use the dome supervision for the door trigger. in order to not trigger the alarm when the truck shuts down after remote start, pick up the door trigger wires from each door and diode isolate them. if you do not have factory keyless entry they are BLACK / YELLOW and BLACK/ pink in a grey plug in the drives kick panel. they are negative polarity. if you have a 4 door with factory keyless the wires are at the BCM, BLACK / YELLOW, BLACK/ pink, BLACK/ light blue and BLACK/ white. use all four and diode isolate them,

Print Page | Close Window