’08 chevy uplander pkg 9

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=110642
Printed Date: May 18, 2025 at 11:35 AM

Topic: ’08 chevy uplander pkg 9

Posted By: gr3atm3linko
Subject: ’08 chevy uplander pkg 9
Date Posted: January 14, 2009 at 10:20 AM

i installed a remote starter on a 2008 chevy uplander, I have an xk06 w/ pkg9 firmware but I do not have the right pk3 wiring schematic for that vehicle. All the diagrams I have are for a 5 pin harness, this only has 3 wire exiting from the pk3 ring, BLACK/ white, pink, and red. does anyone know which wires to use?

Replies:

Posted By: robertsc
Date Posted: January 14, 2009 at 11:36 AM

pkg5 is what you need for firmware

https://www.bypasskit.com/getdocument.aspx?documentid=586

Posted By: gr3atm3linko
Date Posted: January 15, 2009 at 8:40 AM

pkg5 is what i have loaded and installed, key has to be in the ignnition during r-start to avoid codes.i was told to try pkg 9 from tech support but no one knows the wiring...including the dealer.

Posted By: robertsc
Date Posted: January 15, 2009 at 11:06 AM

if you look at the link i provided the diagram is right there

and if can't handle those instructions its time to hand the install to somebody else

Posted By: gr3atm3linko
Date Posted: January 16, 2009 at 10:02 AM

incorrect. the diagram is wrong, it is installed that way now, as per the diagram. Wrong Firmware!

Posted By: robertsc
Date Posted: January 16, 2009 at 4:43 PM

so let see if i can get this right

you have the wrong firmware and your trying to make it work?

Print Page | Close Window