Print Page | Close Window

1994 corvette reverse polarity locks

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=110649
Printed Date: May 19, 2025 at 4:23 AM


Topic: 1994 corvette reverse polarity locks

Posted By: tony24
Subject: 1994 corvette reverse polarity locks
Date Posted: January 14, 2009 at 3:22 PM

I searched and didn't come up with any information on wiring reverse polarity door locks on a corvette. the diagram sheet says the wires are located in the driver kick panel. I have located the wires for lock and unlock but am confused about cutting them in this location because the diagram shows cutting between the switch and actuator. The wires in the kick panel comes from the switch. Can anyone add any insight to this. The lock wire is rd/blk, unlock or/blk. I'm installing a crimestopper FM two way unit. Thanks.



Replies:

Posted By: Mike M2
Date Posted: January 14, 2009 at 6:19 PM
You are cutting them between the drivers switch and the passenger actuator when you tie in at the kick panel.

-------------
Mike M2
Tech Manager
CS Dealer Services


Print Page | Close Window