Print Page | Close Window

2004 chevy blazer, autostart as-1775

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=110658
Printed Date: May 20, 2025 at 10:22 PM


Topic: 2004 chevy blazer, autostart as-1775

Posted By: scottys
Subject: 2004 chevy blazer, autostart as-1775
Date Posted: January 14, 2009 at 5:56 PM

This is my first time with passlock 2003 I am installing autostart AS-1775 in a chev blazer 2004 I need help with the pass lock part of the install and seting it up can you help

-------------
skippy64



Replies:

Posted By: moonliter
Date Posted: January 14, 2009 at 7:00 PM

https://ifar.ca/en/download/96/installation_manual.rev-1.2b.pdf

You only need to use 4 wires from the passlock 2003.

  • black ----- black OR BLACK/ orange at the passlock 2
  • yellow ---- yellow wire at the passlock 2
  • white ----- ( not required ) as long as ign2 is wired up from AS-1775
  • pink ------ ignition at the ignition switch harness
  • purple --- ( not required )
  • brown --- ( not required )
  • blue ------ Ground while running ( white wire of the 12 wire harness of AS-1775 )
  • green ---- ( not required )

make sure the jumper is set on mode 1, after all the connections are made, start the vehicle with key and then adjust the port till the led turns off. If you keep turning the pot, the led will come on again. The sweet spot will be in between the led starts to turn off.




Posted By: scottys
Date Posted: January 14, 2009 at 7:43 PM
Thanks for the info will try this in the am, muchly appreciatted

-------------
skippy64


Print Page | Close Window