04 nissan maxima, remote start

I have installed a CS2900 w/CAN SL2 for bypass into a Maxima with some problems. When it is remoted started the the heater works but no windows, turn signals, radio and no power to the radio/heater screen (which is fine) but, after the car takes over the windows and turn signals still do not work. I have to shut the car off and start it w/the key and everything is OK then. 12 volt=green, ing=sm blk/red, acc=red and I have also connected the wht/blu, start=blk/red, start2=blk/red Anyone ideas? Have beenon phone with tech support ad they can not even figure it out.

BTW, starter 2 should be BLACK / YELLOW.

Sounds silly, but are you sure you have the brake wire hooked up right? Does the engine stop when you get in & hit the brake, after remotely starting? If not, you are still under the remote start power & maybe one of the wire connections you made to the igmition is loose.

Also, use a voltmeter & check for voltage output on all remote start ignition wires. I'm sure one of the ignition wires is not getting powered up somehow. 

-------------
Good Enough Isn't!

And you didn't say exactly what you connected to the WHITE/ blue.

The first step would be to test all of the car's ignition, accessory, and starter wires for proper function during remote start. That is, not visually, but testing with your test light or multimeter.

Starter2 blk / YELLOW (that is what I ment, typo) The brake is hooked up properly, when I get in and hit the brake the car shuts down. Sorry, the WHITE/ blue I have hooked up as another acc, tech support had me hook up another acc wire, the WHITE/ blue tests as an acc on the car. I have tested all the wires from the RS and they all seem to working like they are suppose to. All wires on the car have been tested along with RS with a multimeter. This one is kicking my ass and I'm lost.

Try this experiment:

With the car is running under the power of remote start only, connect your ignition wire BLACK/ red to Red first & then to WHITE/ blue. Do one at a time & see if radio,etc. comes on with either one.

Let me know what happens.

-------------
Good Enough Isn't!

OK, Radio, screen and interior lights come on when ING is connected to WHITE/ blue, but no turn signals doring RS nor when car takes back over from RS. If I shut car off and start w/key turn signals work. Any more ideas????

OK, sounds like the WHITE/ blue is not getting power during remote start.

Now temporarily try connecting the ignition wire BLACK/ Red to Red & WHITE/ Blue together (All 3 together). Tell me if turn signals work.

-------------
Good Enough Isn't!

no turn signals, during RS nor when car takes back over. ????????????????

You have a problem with power to one of the accessory wires. Check them again with a DVM while Rs is on...

-------------
Mike M2
Tech Manager
CS Dealer Services

went through a whole RS cycle and measured all wires during the cycle. All wires are getting 12Volts when they are suppose to.
Measured wires at car and at the RSer.

If I start car w/key and take over w/RS turn signals quit working

OK it really has me puzzled now. I disconnected the D2D wire and just tried to start car and turn signals wand everything works. What does the D2D have to do with the workings of the turn signals?
OK without the D2D connected the car does not start (guess it is not seeing bypass, if I put key into ing barrel the car will start with RS)

You probably interrupted the turn signal wire at the BCM, instead of the LED wire.

Verify carefully that you interrupted pin 38 with the CAN-SL2's blue and blue/black wires.

OK I feel stupid now. Do you know what pin 23 is for on the BCM, (turn signal)? Do you have a pin out of the BCM for the 40 pin?