2000 gmc sierra remote start

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=110880
Printed Date: May 15, 2025 at 8:39 AM

Topic: 2000 gmc sierra remote start

Posted By: Milego
Subject: 2000 gmc sierra remote start
Date Posted: January 21, 2009 at 9:02 PM

I need some help, I have a 2000 Sierra, and I'm trying to install a Viper 7901, I've got everything except the bypass module connected. I'm using a 555L as I' assuming that this is the correct module for this vehicle. My problem is the wiring of this module is my problem as I've never done a remote start before. I'm trying to find 1 wire, and rather that probe for hours, I'd thought I'd ask here. I need to know where to connect the black wire on the module, it's says to hook this to the ground reference wire. Thanks for any help.

Replies:

Posted By: berserk_eagle
Date Posted: January 21, 2009 at 9:49 PM

I put a remote start in my 02 sierra a few months ago. The 3 wires you need, yellow, white, and the black ground reference wires will all be together coming right out of the ignition key cylinder.

-------------
Ryan

Posted By: another-kelly
Date Posted: January 21, 2009 at 10:54 PM

pics always help

edit: but the pic won't show up so follow the link below

click here for the pic

to answer your question, the black from the 555l goes to the ORANGE / black in the passlock 2 harness

Posted By: Milego
Date Posted: January 22, 2009 at 1:18 PM

Ok so I got the momdule installed and it seems to have been a bad module so I swapped it out, but the only other module available was the DLPKGM. I hope someone is familiar with this module because I'm confused again. I know I only need to use three of the wires from it. I know the purple wire connects to pin 2 on the OBDII connector, and the BLUE/BLACK wire connects to the status output from my remomte starter, but where do I connect the PINK ignition output from the module?