1100f and keysense, 2006 tribute
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=111022
Printed Date: June 07, 2024 at 11:20 PM
Topic: 1100f and keysense, 2006 tribute
Posted By: ragj1976
Subject: 1100f and keysense, 2006 tribute
Date Posted: January 26, 2009 at 4:59 PM
Hello Folks, just got an 1100F for a remote start in a 2006 Tribute. I know I need a keysense to shut down the transponder when the actual key is in, but I am confused a bit.. The 1100F takes some RX and TX data signal wires, does that replace the "old style" Keysense? Or am I missing something.. IN other words, all I need on this 1100F is RX/TX/GND and Ignition? Or do I need to grab key sense also?
Thanks
-Roger
Replies:
Posted By: BNLUIS
Date Posted: January 26, 2009 at 7:08 PM
no need to hook up key sense in this car , besides is data.
-------------
Luis
Sound Waves
Is up to the installer to test all wires with a DMM whenever possible.
Posted By: chriswallace187
Date Posted: January 26, 2009 at 10:42 PM
There have been reports of problems when using an RF bypass module on a Tribute/Escape(i.e. one that uses its own transponder or a vehicle key).
When the remote start is activated with a key in the ignition, the vehicle would read two separate transponder codes at the same time and either display a "service" light or go into some kind of protection mode where it wouldn't start for a while(I never personally experienced this so I can't identify the specific problem). The solution to this was a relay activated by the keysense wire that would interrupt the bypass when a key was in the ignition. This shouldn't be a problem with a data bypass, however.
-------------
C Renner's Auto Electronix
My service is cheap, quick, and good - pick any two
Posted By: ragj1976
Date Posted: January 27, 2009 at 6:27 AM
I see.. Another question, with the DEI 1100F Is the GWR lead an output or a turn on for the 1100F.. Or does the 1100F turn on when it see's ignition? The directions are insanely vague.
Thanks
-Roger
Posted By: BNLUIS
Date Posted: January 27, 2009 at 7:33 AM
you need to connect the GWR wire to activate the 1100f,
-------------
Luis
Sound Waves
Is up to the installer to test all wires with a DMM whenever possible.
Posted By: kgerry
Date Posted: January 27, 2009 at 12:41 PM
it is the - turn on input....
-------------
Kevin Gerry
Certified Electronics Technician
MECP First Class Installer
Owner/Installer
Classic Car Audio
since 1979
|