astrostart 2524, fault code 4
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=111164
Printed Date: May 16, 2024 at 12:52 AM
Topic: astrostart 2524, fault code 4
Posted By: johnnieb21
Subject: astrostart 2524, fault code 4
Date Posted: January 30, 2009 at 11:11 PM
Dealer installed Astrostart 2524 in my Dodge Ram 1500. Worked fine until about a month ago. When I attempt remote start, doors lock, lights blink, fuel pump primes, but engine doesn't crank. Then it all shuts down. Brain LED flashed fault code 4, engine failed to crank. Remote sequence to show fault codes flashes the same. Other than that, everything else works fine. Starts everytime with the key. Decided to check out the fuses and wiring today. Fuses all looked good. Unwrapped some of the wiring connections and hadn't seen that bad of a soldering job since I was in high school electronics class. I'm going to go through and re-solder all the connections tomorrow. Also, found a faulty resistor off one of the relays. Was wondering if there's anything else I should look for that would generate this fault code? I would love to get the installation instructions for the Astrostart 2524, just to make sure the correct connections and resistors are being used. Any info would be greatly appreciated.
Replies:
Posted By: KarTuneMan
Date Posted: January 31, 2009 at 1:11 AM
The code that was displayed is for NO tach. What year is your truck? -------------
Posted By: johnnieb21
Date Posted: January 31, 2009 at 10:02 AM
2008, sorry, forgot that in the original.
|