Print Page | Close Window

compustar 2wfm_as does not turn over

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=111266
Printed Date: May 15, 2024 at 3:28 PM


Topic: compustar 2wfm_as does not turn over

Posted By: kel789
Subject: compustar 2wfm_as does not turn over
Date Posted: February 02, 2009 at 9:04 PM

i have compustar_2wfm_as in maxima 97. i left the car dome lamp turned on by accident so it drained the car battery over a few days and drained enough power that i can't start the car. i disconnected and reconnected the battery, thinking that it help to prevent short circuiting the alarm before jumping the car with anther car. a few days after the car was jumped started, i remote started the car but the car did not turn over. when i sat in the car, the dash lights are all lit up but it does not turn over. the car starter is working when started with the car key. the remote starter function seems to work when using it to keep the engine running without a key in the steering column. the alarm appears to arm/disarm fine. could it be the battery issue? not enough juice for the remote starter to turn over? i kinda doubt it when i can start the car with the car key. i am puzzled. does anyone have the same experience?



Replies:

Posted By: james bond 007
Date Posted: February 03, 2009 at 7:01 PM

sounds like the contacts on starter output relay could be gone, you could check this by running a jumper wire from 12volts to the starter output wire coming from the unit 





Posted By: kel789
Date Posted: February 03, 2009 at 7:59 PM
a jumper wire is a regular wire for alarms?

i guess it's ok to use the 12volts power source from the battery. any recommendation, just in case i have a dead relay?

there is a relay between the central unit and the steering column. you want to confirm if relay is actually dead?




Posted By: kel789
Date Posted: February 05, 2009 at 5:41 PM
this is for those who will be experiencing what i am now experiencing.

hold 1+2, tab 3 (1 flash), tab 3 (1 flash), tab 3 (3 flashes),

hold 1+4, tab 3 (1 flash), tab 3 (1 flash), tab 3 (3 flashes),

if the horn goes off in any steps, it means you are too late. you must start over.





Print Page | Close Window