2007 tiburon, parking lights, horn

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=111612
Printed Date: May 05, 2024 at 10:46 PM

Topic: 2007 tiburon, parking lights, horn

Posted By: morbidking
Subject: 2007 tiburon, parking lights, horn
Date Posted: February 15, 2009 at 1:30 PM

need to know how to hook the parking lights up and factory horn

alarm is carvox 2300a this is what it says about the lights

Replies:

Posted By: morbidking
Date Posted: February 15, 2009 at 1:41 PM

it posted before i was done typing

pin2: brown:light 1 output (+) connecttheleftparkinglights of the vehicle

pin3: brown: light 2 output (+/-) out putis 7A (+) and 250ma (-) the light 2 switch (+/-) is on main bord the default is (+) output

Posted By: jinstall
Date Posted: February 15, 2009 at 2:38 PM

I did an 08 recently and it said I needed two wires and I actually didn't. all that means is that it's a separate wire for left and right side lights. so if it does actually need them then you'll have to use a pair of diodes to split the wire to power both circuits.

the horn is very straight forward on that car, just hook it up.

Posted By: jinstall
Date Posted: February 15, 2009 at 2:38 PM

that second wire is not for the horn btw.

Posted By: morbidking
Date Posted: February 15, 2009 at 6:43 PM

jinstall wrote:

that second wire is not for the horn btw.

ok on the horn didnt know if i needed a relay or not

the wiring diagram for my car says i need 2 relays ( NOTE *2 this vehicle has 2 PARKING LIGHT wires, to connect will require 2 extra Relays Part #R30-H) do i need the relays and if so how do i hook them up

Posted By: ckeeler
Date Posted: February 16, 2009 at 3:42 PM

change the default (+) parklight output to (-) and use the blue/orange wire at the headlight switch. it turns on all the lights with only that single negative triggered wire.

Posted By: morbidking
Date Posted: February 16, 2009 at 8:48 PM

ckeeler wrote:

change the default (+) parklight output to (-) and use the blue/orange wire at the headlight switch. it turns on all the lights with only that single negative triggered wire.

will do i will let you know how it turns out