adding power door locks
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=111804
Printed Date: May 13, 2024 at 11:30 PM
Topic: adding power door locks
Posted By: sworrix222
Subject: adding power door locks
Date Posted: February 21, 2009 at 3:27 PM
i have a 2004 chevy silverado base model i also have a valet 562t remote start i purchased 2 2 wire actuators can any one tell me how to wire the door locks with no switches inside the car will the green and blue wire run both door lock actuators..it has a relay satelitre do i need to run seperate relays????thanks shawn
Replies:
Posted By: t&t tech
Date Posted: February 21, 2009 at 5:36 PM
 use this diagram, the blue connects to the unlock output, and the green to the lock.------------- COMMIT YOUR WAY TO JEHOVAH AND HE WILL ACT IN YOUR BEHALF.
PSALMS 37:5
Posted By: loneranger
Date Posted: February 21, 2009 at 6:42 PM
To further simplify, the R/S's BLUE unlock/lock wire goes to the unlock relay. The R/S's GREEN lock/unlock wire goes the lock relay. If the actuators are operating in reverse, then swap the R/S's BLUE and GREEN wires.
-------------
Ideal - cmon dude, add to topics in a useful manner, not stuff that is obvious.
Story - Phzzzt! Hey, what happened?! ... Isn't it obvious?
Moral - Never dismiss the obvious.
Posted By: howie ll
Date Posted: February 22, 2009 at 2:23 PM
You can get really flash here and run a single pole double throw momentary switch accross the green and blue 526 lock output wires before the relay, just ground the centre contact, or use a 5 terminal Spal window switch, ground the centre contact and feed to the two outers. Sorry that nitro BMW guy has teed me off.
|