2004 sequoia wire locations

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=111817
Printed Date: May 23, 2024 at 3:47 PM

Topic: 2004 sequoia wire locations

Posted By: eha1108
Subject: 2004 sequoia wire locations
Date Posted: February 21, 2009 at 9:13 PM

First time post here: I am currently installing a remote start on an 04 Sequoia and have a few areas I need assistance.

First I cannot locate the tech wire as described in the wiring diagram I have, my understanding is this wire will produce an AC voltage between 1 to 6 volts. I have tested every YELLOW /GREEN wire I can find in the drivers kick panel.

Next I need help locating the the IMI and the IMO wires I am using the PKT2 immobilizer bypass, the information I recieved with this told me the IMO is Lt blue / YELLOW pin 26 in the ecm and the IMI is pink/green pin 27 in the ecm I assume these wires are located behind the glove box is this right.

Any help would be greatly appreciated.

Replies:

Posted By: SoundImage
Date Posted: February 22, 2009 at 10:24 PM

you can locate tach signal at the yellow green wire at the ECM behind glove box. and yes those are the correct data wires behing the glove box as well

Posted By: Chris Luongo
Date Posted: February 22, 2009 at 10:43 PM

The photos are long gone now, but I think this post might help you:

https://www.audiogroupforum.com/csforum/archive/index.php/t-11840.html

Posted By: eha1108
Date Posted: February 23, 2009 at 7:43 PM

I appreciate the help, I will not have the opportunity to work on it again until this weekend hope to get it resolved then.