06 nissan frontier and viper 350hv

sup guys?

been a member/lurker here for a long time. this is my first time posting.

im about to install the viper 350hv in my 06 nissan frontier. this is my first attempt at car alarm install. i heard it was basic so i decided to try. my question is, how do i disable the factory alarm so that it wont go off when i use the viper?

can i just install the viper alarm and leave the factory alarm as it is?

chris

	Alarm Disarm		GRAY		(-)		AT BCM MODULE BEHIND DRIVERS SIDE OF DASH ABOVE PEDALS BEHIND DIAGNOSTIC CONNECTOR
	Alarm Arm		LIGHT BLUE		(-)		AT BCM MODULE BEHIND DRIVERS SIDE OF DASH ABOVE PEDALS BEHIND DIAGNOSTIC CONNECTOR

You'll have to disarm the factory alarm, those are the wires you'll be looking for.

-------------
...half of the truth can be worse than a lie. <----Roger Russell said that..

so how do i disarm the factory alarm? do i disconnect the arm/disarmwire? sorry about the noobie question. this is the only thing holding me back right now. thanks.

connect the arm disarm wires and it should disarm upon remote start and unlock

connect the viper arm and disarm right? and disconnect the factory? man, this sounds so simple...sorry guys!!!

i read somewhere that i need to splice a wire and connect it to the ground...do i have to do that?

Take the arm and disarm wires coming off the viper and tap into the arm and disarm wires in the vehicle

sweet! i will do that tomorrow! thanks guys!!!

so i was comparing the diagram from https://www.the12volt.com/installbay/forum_posts.asp~TID~85069 to...


viper (listed below)

4-pin shock sensor harness
red + constant power input
black - chassis ground input
blue - multiplex input zone 2
green - multiplex input zone 4

3-pin wire door lock harness
green - lock + unlock output
empty
blue - unlock + lock output

12-pin primary harness
orange to starter kill relay
white vehicle parking light wire
WHITE/ blue programmable output
BLACK/ white domelight supervision relay (optional)
green to - door wire switch
blue optional hood or trunk pin
violet to + door switch wire
black chassis ground
yellow key switch
brown siren's red wire
red battery
RED / white optional accessory



can someone kinda point me in the right direction. i want at least the keyless entry and shock sensor working. any help would be appreciated.

which one is the lock and unlock for from the viper? from the 3-pin, it's confusing since it says both unlock and lock for both wires.

one will be positive unlock and negative lock. So when you push the lock button it will send out a negative pulse on one wire and a positive on the other. So just look at the wiring diagram and use the colour that says negative lock next to it for lock and the other one for unlock. Soory I forget what wire actually does what on this system

so i got everything to work...except the park lights...it doesnt blink when i unlock/lock...i followed the wiring diagram but no luck at all...any ideas?

All you have to do is connect it should be a white wire coming off the viper to the red parking light wire in the truck. Just make sure the jumper is in the correct position when looking at the brain the main connector will be on the left. The jumper must be connected to the middle pin and right pin. Which is the default setting.
Did you test your parking light wire in the car?
Also confirm that your fuse on your white parking light wire is not blown

thanks chadwa. ill check that today. the jumper is in the right position and the fuses are good. ill have to find the red wire though.i know i can trace it back from the bay to the kickpanel. thanks again. ill let you know what happens.