2008 mazda 6 wiring

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=111925
Printed Date: September 12, 2025 at 5:25 AM

Topic: 2008 mazda 6 wiring

Posted By: jpinusmc
Subject: 2008 mazda 6 wiring
Date Posted: February 25, 2009 at 4:55 PM

All,

I am looking for the wiring diagram for a 2008 Mazda 6. Can anyone help me out with this?

Replies:

Posted By: sonyw810
Date Posted: February 28, 2009 at 10:36 AM

Same as the 2007, I can not copy my data base but I compared the two and they are the same. Hope thast helps

Posted By: jpinusmc
Date Posted: March 01, 2009 at 10:10 AM

Thank you for the help, with the lock/unlock wire, the data sheet says it is in the passenger kick near the glove box. Is there a module there I should be able to see? There are only two connectors in the kick and one ground connection higher. Is there another place to find this wire?

Also, can I use a 456lw on this wire?

Thanks again, without this site I would be totally lost.

Posted By: Chris Luongo
Date Posted: March 01, 2009 at 10:50 AM

I did a 6 not too long ago.....I think it was a 2004 or 2005 or so, but it should be pretty much the same car.

The wires come into the driver's side of the car from the driver's door boot.

I was able to find the wire up high in the driver's kick panel, as it comes in from the driver's door. It wasn't the easiest, but I did find it there.

You might have some luck if you get under the dash with a good light, and with your free hand, reach into the car's doorjamb and wiggle the rubber wiring boot, to see if you can get the wires inside the car to wiggle around too.