Print Page | Close Window

clifford intelliguard fob troubleshooting

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=112091
Printed Date: May 25, 2025 at 7:51 PM


Topic: clifford intelliguard fob troubleshooting

Posted By: techman41973
Subject: clifford intelliguard fob troubleshooting
Date Posted: March 03, 2009 at 8:32 PM

I have a Cifford Intelliguard 7000 Alam system installed in my vehicle. I have a master remote fob and a smaller one as well. After I replaced the battery in my master remote with a fresh one, the Red indicator LED glows solid red and the fob won't work (engage or disengage the alarm). Does anyone know if this means its fried or is it stuck in some mode that I can find a way out of. Thanks




Replies:

Posted By: howie ll
Date Posted: March 04, 2009 at 2:33 AM
Probably find one of the switches has shorted. Not uncommon on G3 early G4 remotes.


Print Page | Close Window