09 charger starter wire

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=112416
Printed Date: May 13, 2025 at 3:59 AM

Topic: 09 charger starter wire

Posted By: jnardz
Subject: 09 charger starter wire
Date Posted: March 16, 2009 at 11:38 AM

the tech sheet i have says that the starter wire provided is not to be used for remote start. has anyone already done a 09 charger and if so wut wire did u catch for STARTER wire?

Replies:

Posted By: Chris Luongo
Date Posted: March 16, 2009 at 1:44 PM

Have you tried the search feature already?

Posted By: jnardz
Date Posted: March 16, 2009 at 5:17 PM

yea i already tried that but found nuthin

Posted By: 91stt
Date Posted: March 16, 2009 at 8:17 PM

Are you looking to do a starter disable or remote start? Starter disable has to be picked up at the Total Integrated Power Module that is located near the passenger strut tower. Remote start needs a interface module.

Posted By: Mike M2
Date Posted: March 16, 2009 at 9:33 PM

The starter wire for RS is data. You need a module to make it work.

-------------
Mike M2
Tech Manager
CS Dealer Services

Posted By: rustic_comfort
Date Posted: March 19, 2009 at 8:15 PM

I have used this module on the new smart key setup Xpresskit DLPKKICH3. But had to flash it back to version 1.10 to get the ignition to work correct but was unable to get car to start, so then I cut the accy wire during crank to get the car to start. The wafer with bypass kit was nice but you have to make sure that the board is secure or you will not get a good connection. Hope this helps...

Posted By: jnardz
Date Posted: April 04, 2009 at 5:15 PM

thanks for the help rustic_comfort...

Print Page | Close Window