Print Page | Close Window

ignition wiring - help asap

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=11294
Printed Date: December 21, 2025 at 11:11 PM


Topic: ignition wiring - help asap

Posted By: ian313
Subject: ignition wiring - help asap
Date Posted: March 22, 2003 at 6:16 PM

I'm trying to hook up a crimestopper alarm/remote start in a 94 civic. My ignition has 3 positions.

1. Acc
2. Run
3. Start

My ignition switch wiring is:

Blk/wht - Hot in start
Blk/yel - Hot in run and start
Wht/blk - Hot in acc and run
Yel - Hot in run

My alarm has a wire for:

start - i'll hook to blk/wht
ign - i'll hook to blk/yel

acc - where does this go? I thougt wht/blk.  Install guide on this site says yel.

then it has one more for "ign2 or acc2 if necessary"

Do I need to hook this up or is it for a car with an ignition switch with another position?

If I do, where does it go?

Also, the alarm has two wires for battery power.  Should I run those directly to the battery or can I hook them to the constant power wire in my ignition switch.

Any help is greatly appreciated.




Replies:

Posted By: Dreadlock
Date Posted: March 22, 2003 at 8:12 PM
here is the wiring info:
constant power-white(yes you can hook your power wires to this)
starter-BLACK/ white
ignition-BLACK / YELLOW
accessory-yellow
lock-GREEN / WHITE
unlock-GREEN/ red
parking lights-RED / black
door trigger-lt.GREEN/ red
tach-blue(two pin connector under hood near batt)
brake-GREEN / WHITE

dont worry about the other teo wires for acc/2 and ign/2


Print Page | Close Window