diode
Printed From: the12volt.comForum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=113250
Printed Date: April 27, 2024 at 4:01 PM
Topic: diode
Posted By: BrianB1975
Subject: diode
Date Posted: April 18, 2009 at 1:39 PM
Replies:
Posted By: ckeeler
Date Posted: April 18, 2009 at 1:43 PM
the wire is cut and the diode is put "inline". like this
Posted By: Powermyster
Date Posted: April 18, 2009 at 2:05 PM
Posted By: i am an idiot
Date Posted: April 18, 2009 at 3:06 PM
In order to be able to use the diode again if necessary, I strip insulation off of some 18 Ga. primary wire and insert it over the legs as depicted in the first diagram. The wire insulation is red. Then insert heat shrink tubing over each end of the cut wire. Solder the wire to the diode as depicted in diagram 2. the solder is yellow. Then slide the heat shrink tubing over the solder joint and shrink it. As depicted in the last diagram.
