shock sensor doesn’t trigger alarm
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=113498
Printed Date: May 15, 2024 at 1:19 PM
Topic: shock sensor doesn’t trigger alarm
Posted By: mightymegit
Subject: shock sensor doesn’t trigger alarm
Date Posted: April 29, 2009 at 7:51 PM
Hey everyone, I just got done installing my Compustar cm3300 and everything works except the Shock sensor, the little led on it changes colors based on movement like it's supposed to, it just doesn't trigger a full alarm.
Right now the only way I can trigger an alarm is to press lock on my remote and then open a door from the inside. So the door triggers set it off properly.
It's in a '95 Acura Integra.
Any help is very much appreciated!
Replies:
Posted By: mightymegit
Date Posted: April 30, 2009 at 2:09 PM
Does anybody have some troubleshooting advice for me?
I've already tried unpluging the 12v power from the compustar brain for about 5 minutes, this doesn't fix the problem.
Also could a bad ground cause this? As I said everything else works fine, it just doesn't trigger an alarm when I shake it with it set on any sensitivity.
Posted By: mightymegit
Date Posted: April 30, 2009 at 3:54 PM
Boy do I feel stupid.
On my two way remote I thought I was toggling shock this whole time when instead I was toggling valet. I didn't notice the little -(dash) in (I-III)-shock which means to hold it.
|