Print Page | Close Window

2004 chrysler 300m remote start problems

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=113618
Printed Date: May 14, 2025 at 11:28 AM


Topic: 2004 chrysler 300m remote start problems

Posted By: raab3485
Subject: 2004 chrysler 300m remote start problems
Date Posted: May 05, 2009 at 6:25 PM

Hey guys,

I'm installing a viper remote start/alarm into a 2004 Chrysler 300m, and I'm using a DEI 556UW to bypass the sentry key system.

The problem I'm having, is that with the 556UW hooked up, with the key in the box, and only the red (12volt), blue (negative status input), and black (ground) hooked up to the module, the Remote start works beautifully, but if you try to start the car with the key, it runs for a couple of seconds and then shuts down. I tried hooking up the keysense wire out of the module, and it just reversed the problem. It would then work fine with the key, but it wouldn't stay running when you remote start it.

I can't get the vehicle to start with the remote start, stay running, and start with the key and stay running. What am I missing?




Replies:

Posted By: raab3485
Date Posted: May 05, 2009 at 6:38 PM
Nevermind, I'm an idiot. It helps if you read the directions and then you'd know not to hook up the pink ignition wire from the 556uw in this application.


Print Page | Close Window