08 kia rondo
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=114155
Printed Date: November 01, 2025 at 5:40 AM
Topic: 08 kia rondo
Posted By: chev104275
Subject: 08 kia rondo
Date Posted: June 01, 2009 at 3:17 PM
ok heres the issue im having i put a DEI avital 4103 into this car and all was well so i thought im using the white and WHITE/ black for the locks diode isolated bands facing the module and the locks work ok till i close the doors and lock them wait about 5 mins then come back to the car and the car wont unlock it but will lock when this happens the cars lock switch on the door doesnt respond to unlock either but yet still locks fine till i manually unlock the door using the key in the door cyl. then all is well again if i unplug the lock wires from the R/S module the problem isnt there any ideas ? P.S i also have this same issue on a 06 explorer same system
Thanks in Advance Joe
-------------
If i Can't Install it I Don't need it Joe
Replies:
Posted By: Velocity Motors
Date Posted: June 01, 2009 at 8:32 PM
Whay are you using diodes for the unlock and lock wires ? | Power Lock | white | - | dr kick or BCM, 26 pin plug, pin 22 | | Note:The BCM (Body Control Module) is above the brake pedal switch. |
| | Power Unlock | WHITE/ black | - | dr kick or BCM, 26 pin plug, pin 9 | | Note:The BCM (Body Control Module) is above the brake pedal switch. To unlock the driver door only, use blue (-) at the BCM, 22 pin plug, pin 16. |
|
------------- Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: tommy...
Date Posted: June 01, 2009 at 10:42 PM
Wow, having almost the exact same problem on a 01 Camry! Few posts down...No diodes
-------------
M.E.C.P & First-Class
Go slow and drink lots of water...Procrastinators' Unite...Tomorrow!
Posted By: chev104275
Date Posted: June 02, 2009 at 5:26 AM
i installed it without diodes first then tryed with diodes same problem im using those wires of done these cars before with no issues the wire tested right im also hooked into the arm (gray)and disarm (brown) wires for the factory alarm system
-------------
If i Can't Install it I Don't need it Joe
Posted By: chev104275
Date Posted: June 02, 2009 at 10:58 AM
do you think using a relay to control the unlock on just the drivers door acuator will solve this ??
-------------
If i Can't Install it I Don't need it Joe
|