Print Page | Close Window

Cherokee-96 keyless entry bypass?

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=11417
Printed Date: September 09, 2025 at 8:02 PM


Topic: Cherokee-96 keyless entry bypass?

Posted By: ILV Industri AB
Subject: Cherokee-96 keyless entry bypass?
Date Posted: March 25, 2003 at 1:20 AM

Hi.  Is there anyone that knows how to disarm the original keyless entry with the built in immobilizer on a Jeep Grand Cherokee-96?  We have problems to deactivate the system in some places. We would like to replace it with a new alarm instead.  Is iit possible?

/Math




Replies:

Posted By: DeathsJester12V
Date Posted: March 25, 2003 at 5:35 PM
ok..the Factory alarm disarm wire is purple / YELLOW (-) in the door harness. From what I know of the Factory Alarm arms when you lock the doors. i don't think you can "remove" it. However, if you will be putting in an alarm made by DEI you can use DEI's Jeep Databus Interface Module (JIM) part number 455T. it's a simple two wire connection into the vehicles underdash databus. It allows aftermarketsystems to contol the factory arming/disarming, domelight supervision, door locking, drivers door unlocking/all door unlocking, and other stuff. and I'm not sure on this, but it might also be compatiable with other alarms systems besides those made by DEI...might wanna check that out...but that's the best way I can see about the Alarm problem man....hope I somewhat helped..

-------------
Đễẳ†ђş 12\/ Ĵęśŧē®™


Print Page | Close Window