honda accord 98 v6

im installing alarm on my honda accord 98
the alarm model is crime stopper sp100 and i just finish   but i cant disarm the factory alarm when i disarm the one that i installed the factory one star bi bi bi bi bi bi bi working . on the diagram it show me a wire that it have to conect to disarm the factory alarm but on the sp100 witch wire shoul i use the unlock or wich one thanks for your help .

That was tough to read...What wire did you use for factory dis-arm from alarm...What is the color and location of wire you connected to in car...?

	Battery		WHITE		(+)		PASSENGER SIDE FUSE BOX OR IGN HARNESS
	Ignition 1		BLACK / YELLOW		(+)		PASSENGER SIDE FUSE BOX OR IGN HARNESS
	Starter 1		BLACK/ WHITE		(+)		AT HEATER AC FAN MOTOR
	All Door Trigger		BLACK/ WHITE		(-)		PASSENGER SIDE FUSE BOX
	Trunk Trigger		ORANGE		(-)		DRIVERS KICK GREY MOLEX PLUG
	Hood Trigger		YELLOW		(-)		PASS SIDE GRN PLUG
	Alarm Disarm		BLUE
	Alarm Arm		BLUE/WHITE
	Parking Lights		RED / BLACK		(+)		FUSE BOX

-------------
M.E.C.P & First-Class
Go slow and drink lots of water...Procrastinators' Unite...Tomorrow!

im not sure of that model R/S but there should be a wire that is labeled Factory Alarm Disarm or FAD   if your car is and EX model the wire should be inside the drivers door at the power window switch   if its the LX model the wire should be at the keyless entry module under the drivers side of the dash   to test this wire put your red meter lead on 12 volts and your black lead on the suspected wire and turn the key in the lock on the outside of the drivers door to unlock your meter will read 12v when you turn the key to unlock and close to 0 at rest

Good Luck

-------------
If i Can't Install it    I Don't need it   Joe

yes the car it is ex its on the driver door the wire but from the sp100 crimestopper witch wire should i use   i located the wire on the car but on the alarm witch wire i use the unlock thank

there should be a wire in the manual for the crime stopper that says FAD or factory alarm disarm     can you post a pic of the wiring diagram ?

-------------
If i Can't Install it    I Don't need it   Joe

This is ONLY an alarm, not a remote start, right?

Forget about going into the driver's door, that's an unnecessary timewaster.

Go to the passenger fusebox.

I forget the colors but you can probably find them here if you search.......there's one wire that tests as ground if you turn the key cylinder in the passenger door to the unlock position, and another that makes a ground if you turn to the lock position.

Again, test while turning the key on the outside, NOT using the switch on the door.

I think the wiring sheet will list those as "factory alarm disarm' and "factory alarm arm."

Anyway, you just connect the lock output from your alarm to the arm wire on the car....unlock from the alarm to the disarm wire in the car, and that's it. It'll lock, arm the factory alarm and the aftermarket one........and unlock and disarm the factory too.

thanks to everybody for the info gracais bye.com