compustar p2w900 as
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=114344
Printed Date: May 11, 2024 at 1:00 PM
Topic: compustar p2w900 as
Posted By: hyisbm
Subject: compustar p2w900 as
Date Posted: June 09, 2009 at 7:41 PM
before I tear open the dash again, just wanted to see if anyone has a solution first.
car is a 2000 Grand Caravan
Everything works fine except when I arm the system. I get three chirps telling me a door is open. I checked and made sure all the doors were completely close and still nothing. Only thing I can think of right now is that we switched the polarity settings and it may be on the wrong one. Will this cause the issue I'm having? If not, what could be causing it? I will check it tomorrow.
Replies:
Posted By: tommy...
Date Posted: June 09, 2009 at 9:24 PM
What wire on the car did you use...? | All Door Trigger | | BROWN / GREEN | | (-) | | IN PLUG AT VEHICLE FUSEBOX |
------------- M.E.C.P & First-Class
Go slow and drink lots of water...Procrastinators' Unite...Tomorrow!
Posted By: hyisbm
Date Posted: June 09, 2009 at 9:39 PM
I used the BROWN / white(dome light). Would that make a difference?
Posted By: Velocity Motors
Date Posted: June 09, 2009 at 9:57 PM
You have to use the RED / WHITE wire for the door trigger on the Compustar system.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: hyisbm
Date Posted: June 10, 2009 at 7:24 AM
I did use the RED / white from the alarm and connected it to the BROWN / white in the car.
Posted By: tommy...
Date Posted: June 10, 2009 at 8:02 AM
Did it Always do this...? I dont think the wrong polarity would do that, but not to familiar w/ comp systems...Time to bust out the meter and see whats going on...What polarity is the dome light...Just go ahead and switch it and see if problem goes away...If negative trigger...Put red lead in 12v...Probe door trigger w/ black lead...Roll window down and open and shut the door...Whats it reading...?
-------------
M.E.C.P & First-Class
Go slow and drink lots of water...Procrastinators' Unite...Tomorrow!
Posted By: tommy...
Date Posted: June 10, 2009 at 8:06 AM
Upon further review...I think i do remember a car coming back due to 3 chirps during arming and it was the wrong door trigger wire off of alarm(system had a wire for + and -). So give it a try...Test first...
-------------
M.E.C.P & First-Class
Go slow and drink lots of water...Procrastinators' Unite...Tomorrow!
Posted By: Velocity Motors
Date Posted: June 10, 2009 at 8:23 AM
What CPU do you have ? CM5000 or the CM4000 ?
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: hyisbm
Date Posted: June 10, 2009 at 8:25 AM
CM4000
Posted By: Velocity Motors
Date Posted: June 10, 2009 at 8:50 AM
There's a jumper that is set for (-) or (+) polarity for the CM4000. Make sure it's set for (-). Also, the BROWN / WHITE wire you used is not right, use the BROWN / GREEN wire at the same location and set the polarity for (-) at the jumper pins.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: hyisbm
Date Posted: June 10, 2009 at 9:50 AM
I'll give it a try later on. The thing is I used the BROWN / white for my old Viper and it worked fine.
|