2005 mercury mountaineer

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=114439
Printed Date: May 05, 2024 at 1:00 PM

Topic: 2005 mercury mountaineer

Posted By: nomad1891
Subject: 2005 mercury mountaineer
Date Posted: June 14, 2009 at 12:58 AM

Hi everyone. I'm looking for the wiring diagrams for a 2005 mercury mountaineer premier. I'm installing a Python 1401 remote start and using a PKFM xpresskit. does anyone have any opinions about this remote start? also, is there a way to program the python remote to control the existing keyless entry. i want to keep the oem keyless entry and not have to carry around two remotes. if not, i guess i will just carry around two remotes, o well.

thanks

Replies:

Posted By: tommy...
Date Posted: June 14, 2009 at 8:14 AM

Battery	YELLOW	(+)	IGNITION SWITCH HARNESS
Ignition 1	RED / LIGHT GREEN	(+)	IGNITION SWITCH HARNESS
Accessory 1	DARK GREEN/ LIGHT GREEN	(+)	IGNITION SWITCH HARNESS
Starter 1	RED	(+)	IGNITION SWITCH HARNESS
Anti-Theft Type	FORD PATS® OR SECURILOCK® VEHICLE IMMOBILIZER
Anti-Theft Descript	THE KEY SENDS AN RF SIGNAL TO THE BCM MODULE THROUGH AN ANTENNA LOCATED AROUND THE IGNITION CYLINDER
Key Sense	BLACK/ LIGHT GREEN	(+)	IGNITION SWITCH HARNESS
Neutral Safety	WHITE/ RED	(+)	IGNITION SWITCH HARNESS
Tachometer	GRAY	(AC)	AT PCM MODULE
Crankshaft Sensor	GRAY	(AC)	AT PCM MODULE
Camshaft Sensor	GRAY/RED	(AC)	AT PCM MODULE
Speed Sense	GRAY/BLACK	(AC)	RADIO HARNESS
Parking Lights	BROWN	(+)	AT VEHICLE LIGHT SWITCH
Brake Lights	LIGHT GREEN	(+)	AT SWITCH ABOVE PEDAL
Reverse Lights	BLACK/ PINK	(+)	DRIVERS DOOR SILL HARNESS OR TRAILER CONNECTOR
Horn	DARK BLUE	(+)	AT CSM MODULE
Anti Theft RX	WHITE/ LIGHT GREEN	(+)	AT PATS MODULE
Anti Theft TX	GRAY/ORANGE	(-)	AT PATS MODULE

	Power Unlock		PINK/LIGHT GREEN		(-)		DRIVERS KICK PANEL OR REAR HATCH LOCK SWITCH
	PowerLock		PINK / YELLOW		(-)		DRIVERS KICK PANEL OR REAR HATCH LOCK SWITCH

-------------
M.E.C.P & First-Class
Go slow and drink lots of water...Procrastinators' Unite...Tomorrow!

Posted By: tommy...
Date Posted: June 14, 2009 at 8:16 AM

	Module 1		PCM - ON PASSENGER SIDE OF FIREWALL
	Module 2		ABCM - BEHIND DRIVERS SIDE HEADLIGHT
	Module 3		CSM - BEHIND TRIM NEAR RIGHT REAR SEAT

The door locks are also at the CSM module...You do currently have 2 ign keys? There is not to many connections on the bypass, but using a d2d (does the 1401 have data plug)will further reduce w2w connections. Either way...it is not bad

-------------
M.E.C.P & First-Class
Go slow and drink lots of water...Procrastinators' Unite...Tomorrow!

Posted By: nomad1891
Date Posted: June 14, 2009 at 4:36 PM

yes i do have the two keys. thanks, that was quick. any tips before i start. this will be the second remote start install but first with the bypass stuff, so wish me good luck.

Posted By: nomad1891
Date Posted: June 14, 2009 at 4:40 PM

does anyone know if the python 1401 comes with the cable, if not, where can i get it. no d2d cables on the python website.

Posted By: nomad1891
Date Posted: June 14, 2009 at 4:50 PM

i think i found my answer, the expresskit comes with a 10 pin and 4 pin harness, so i believe that the 4 pin harness is the d2d cable.

Posted By: tommy...
Date Posted: June 14, 2009 at 4:52 PM

The cable comes w/ the bypass...And even if not... it is only a few more wires...If the 1401 if the same as the 1400 then yes door locks will work fine

-------------
M.E.C.P & First-Class
Go slow and drink lots of water...Procrastinators' Unite...Tomorrow!