07 dodge charger remote start diagram

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=114521
Printed Date: May 24, 2024 at 2:57 PM

Topic: 07 dodge charger remote start diagram

Posted By: soundnsecurity
Subject: 07 dodge charger remote start diagram
Date Posted: June 17, 2009 at 5:43 PM

hey, does anyone have a link for the diagram on how to wire the relays for remote start. ive tried to look it up but all it gives me is that i need a negative 2nd starter (violet/brown) through a 180 ohm resistor but im almost positive there was more to it than that the last time i did one of these.

thanks, Daniel

-------------

Replies:

Posted By: Velocity Motors
Date Posted: June 18, 2009 at 8:05 AM

Use a bypas module. It's waaaaay easier.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA

Posted By: racerjames76
Date Posted: June 18, 2009 at 9:10 AM

Installogy says ground through 600 ohm resistor for accessory and ground through 180 ohm resistor for starter. If you are using this method be sure to cut the mux wire to isolate the bcm side. If you dont you can get additional resistance from the key cylinder itself!

Posted By: profuse007
Date Posted: June 18, 2009 at 5:21 PM

https://documents.audiovox.com/700821.pdf

-------------
Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).

Posted By: soundnsecurity
Date Posted: June 21, 2009 at 9:22 AM

racerjames76 wrote:

Installogy says ground through 600 ohm resistor for accessory and ground through 180 ohm resistor for starter. If you are using this method be sure to cut the mux wire to isolate the bcm side. If you dont you can get additional resistance from the key cylinder itself!

well thanks, but its too late. i already did the install and it starts( tested with the key, no bypass yet) but the check engine light is on now so i will go back and do it right now that i know the acc resistor value. ive done one of these before a few years back and i knew there was more than just the 2nd starter.

-------------