asianwolf dual zone proximity sensor prob
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=114601
Printed Date: May 17, 2025 at 2:02 AM
Topic: asianwolf dual zone proximity sensor prob
Posted By: reelizmpro
Subject: asianwolf dual zone proximity sensor prob
Date Posted: June 21, 2009 at 2:52 PM
So I diode isolated the prewarn and full contacts for my Asianwolf proximity sensor. Prewarn is fine. The problem I'm having is that the full contact isn't working right. There is a sensitivity threshold where it doesn't trigger at all or it triggers all the time. I cannot find a middle ground. The dual shock and prewarn of the proximity sensor all work fine. I don't know what to make of it...bad unit?
Replies:
Posted By: reelizmpro
Date Posted: June 22, 2009 at 3:06 PM
Got off the phone with Wolf innovations. They're local so I'm going to drive by there and swap out the unit. A warning to those buying this unit, adjust the knobs by hand only. I used a small flathead and twisted one of the cheap plastic knobs off.
Posted By: reelizmpro
Date Posted: June 23, 2009 at 8:45 PM
After searching various threads on this site. I found a post by someone claiming that the Wolf proximity sensor MUST have it's own separate power source. Didn't make much sense to me but I tried it anyway and it worked! The sensor is fully operational now.
|