clifford prox.
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=114693
Printed Date: May 15, 2024 at 7:27 AM
Topic: clifford prox.
Posted By: lilmill
Subject: clifford prox.
Date Posted: June 25, 2009 at 8:25 PM
I just replaced my viper 500 with a new 350hv. I have a two stage clifford proximity sensor which has quit working. The alarm has a straight across swap like for like wires, except it seems that I have a blue lead going to the prox sensor that is not hooked up.I donot remeber if it has hooked up. I cannot get any lights to come on the prox. I have checked and I do have voltage going to it. I cannot read the model number but it has the remote adjustment box to set inner and outer zones.
Replies:
Posted By: howie ll
Date Posted: June 26, 2009 at 4:47 PM
The blue wire is the outer zone. The only unit to work on both would be the 508d. Join blue and green on the prox. Wait for 4 secs after powering up before testing, also I believe the black ground wire only grounds when armed. You can easily bench test the unit to see if it's working.
Posted By: lilmill
Date Posted: June 26, 2009 at 4:54 PM
I wiLl try blue to green. Mine used to be active even with it not armed because I remember driving the jeep and seems the lights on the adjuster blinking. I'm thinking the unit is dead. I get no lights but I have tested the power and ground going into it.
|