LED status doesn’t reset

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=11482
Printed Date: September 12, 2025 at 4:02 PM

Topic: LED status doesn’t reset

Posted By: bastantena
Subject: LED status doesn’t reset
Date Posted: March 26, 2003 at 3:07 PM

please help! i have a clifford matrix rs2 alarm. when the alarm is triggered, my LED status indicator doesn't reset itself when i start my car.

primary harness

orange - starter kill relay
white - vehicle parking light
WHITE/ blue - (-)rplemote start momentary switch [i did not hook this up]
BLACK/ white - domelight supervision [i did not hook this up]
green - (-) door switch wire
blue - optional sensor, i used this for my hatch
viloet - (+) door witch wire [i did not hook this up]
black - ground
brown - siren
red - constant power
RED / white - vehicle trunk release wire [i did not hook this up]

am i missing a connection somewhere? thanks in advance

Replies:

Posted By: floaterr
Date Posted: March 27, 2003 at 7:53 AM

I do not see in this list where you hooked up the IGN wire.. Usually this is whay resets the alarm memory.

Posted By: bastantena
Date Posted: March 27, 2003 at 10:19 AM

i see! i have noticed that connection reading up on the introduction section of the car security on this site.

what if there is no wire on the primary harness for this? how would i go about and doing it? would it be possible that that hook-up is on another harness?

Posted By: cpgoose
Date Posted: March 27, 2003 at 11:09 AM

What kind of alarm do you have?

Posted By: bastantena
Date Posted: March 27, 2003 at 11:37 AM

clifford matrix rs2.