Print Page | Close Window

2010 tundra, viper 5901

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=115200
Printed Date: May 03, 2024 at 1:36 AM


Topic: 2010 tundra, viper 5901

Posted By: feroz
Subject: 2010 tundra, viper 5901
Date Posted: July 20, 2009 at 9:08 PM

hi there,

Does anyone have a wiring diagram/advice for a 2010 toyota Tundra, i need to install the viper 5901 on it.

Thanks!!




Replies:

Posted By: jeraldobunkster
Date Posted: July 21, 2009 at 12:34 AM
https://www.directechs.com/DirectWire/PrintVehicleSmall.aspx?VehicleID=24809&Section=AllProducts




Posted By: chev104275
Date Posted: July 21, 2009 at 6:44 AM
Dont have much info but here is what i have

Battery GO DIRECTLY TO BATTERY (+) ENGINE COMPARTMENT   
Ignition 1 BLACK (+) IGNITION SWITCH, PIN 6 OF 8 PIN PLUG   
Ignition 2 LIGHT GREEN (+) IGNITION SWITCH, PIN 7 OF 8 PIN PLUG   
Accessory 1 GRAY (+) IGNITION SWITCH, PIN 7 OF 8 PIN PLUG   
Starter 1 GREEN (+) IGNITION SWITCH, PIN 2 OF 8 PIN PLUG


-------------
If i Can't Install it    I Don't need it   Joe




Posted By: feroz
Date Posted: July 21, 2009 at 7:44 AM

thank you for the info. I do not have access to directechs, hope someone can post whatever info they can get from their. It will sure help me out a lot!

Thanks.





Posted By: KarTuneMan
Date Posted: July 21, 2009 at 8:26 AM

The search button is your friend...

This is for an 09. They are the same!



-------------




Posted By: Steven Kephart
Date Posted: July 22, 2009 at 1:03 AM
You should also be able to use the large 4 awg wire going into the fuse box for 12v constant.




Posted By: feroz
Date Posted: July 22, 2009 at 7:18 AM
Thanks for all the info, how about remote start, where do i get a TRANSPONDER IMMOBILIZER BYPASS for it?




Posted By: profuse007
Date Posted: July 22, 2009 at 11:09 AM
for keyless bypass, you can find it on ebay ads-tb idatalink. you'll need a device to flash it.

-------------
Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).




Posted By: Steven Kephart
Date Posted: July 23, 2009 at 1:21 AM
Or you could go to a Compustar dealer to purchase the Idatalink module and they can flash it for you.




Posted By: legap
Date Posted: July 25, 2009 at 12:15 AM
Google  the 5901 Go to tundratalk.net it will be under wleeb and a exel spread sheet with all the plug locations for 2007. Should be close. it was identical to my 2008 





Print Page | Close Window