2007 jeep wrangler transponder bypass

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=115303
Printed Date: May 09, 2025 at 3:05 AM

Topic: 2007 jeep wrangler transponder bypass

Posted By: domenic73
Subject: 2007 jeep wrangler transponder bypass
Date Posted: July 26, 2009 at 8:06 PM

I've installed a Viper 5701 alarm with remote starter in a 2007 Jeep Wrangler Unlimited. I used the DLPKKICH3 to bypass the transponder. I followed the M2 installation type but I am unable to find any wires matching the CAN Low and CAN High wires. The manual shows them as a twisted pair that are White (or WHITE/ Pink) and WHITE/ Orange located in the kick panel. There is nothing in the kick panel even remotely matching the wires. Has anyone done this type of bypass in this vehicle? If not, can someone tell me how to test or find these wires?

Thank you,

Dom V

-------------
Dom V

Replies:

Posted By: profuse007
Date Posted: July 27, 2009 at 11:01 AM

canH- WHITE/ black
canL- WHITE/ lt. blue
located at the immobilizer transceiver, at key cylinder.

look on idatalink.com under support and installation manual. look in document ADS-DLSL-CH3, page 13

-------------
Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).

Posted By: domenic73
Date Posted: August 07, 2009 at 11:56 AM

Ok, so I was able to find those wires and connect to them. The only problem that I am having is that the truck will not remote start unless I am in it and pressing the clutch while it's starting. Otherwise it will not crank. Does anyone know if I need to bypass the clutch or should I be using another starter wire other then the negative trigger wire on the ignition harness?

-------------
Dom V