2009 silverado steering wheel cover

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=115313
Printed Date: April 26, 2024 at 11:03 AM

Topic: 2009 silverado steering wheel cover

Posted By: jmsounds
Subject: 2009 silverado steering wheel cover
Date Posted: July 27, 2009 at 10:53 AM

hello every one i don't know if this question has been ask before but i work in a few late model chevy trucks 2007 and up i usually have problem accessing the wires at the transponder to install the bypass the problem is i have not figure out how to take the lower cover of the steering wheel cover due to the tilt steering wheel adjuster is there anything on this on how to remove this tilt switch

thanks for any help

Replies:

Posted By: yimke
Date Posted: July 27, 2009 at 10:23 PM

If i remember right there is a torx screw that attaches the adjust lever to the column. Just have a peak in there and see.

Posted By: robertsc
Date Posted: July 28, 2009 at 4:13 PM

lever slides towards yourself easy to pull off

Posted By: jim hunter
Date Posted: July 28, 2009 at 9:20 PM

the tilt wheel lever just pops out, put a fibre stick(or other non marring item )between arm and column and POP it off towards the drivers door, then the cover just unsnaps from the front(steering wheel side) first, sometimes a little tricky to line back up for reinstall but not bad after you do it a few times
impala has torx screw holding cover on yimke, but lever still just unpops on those too

Posted By: yimke
Date Posted: July 28, 2009 at 10:48 PM

That's right. I guess it has been a while since I have done a Remote start in the Chevy lineup. *Waits for winter*

Posted By: jmsounds
Date Posted: July 30, 2009 at 2:50 PM

so i just pull the tilt lever toward the driver door i try but it was hard and i'm afraid of breaking it so there is no screw on this one ? thanks for your respond to all i'll try it again when i get another

Posted By: joch1314
Date Posted: July 30, 2009 at 3:06 PM

Yup, that's how it comes off. Do it little by little, it's in there pretty good, especially if it's never been out before, but definitely no screw there. And yes, pry (pull) towards the drivers door!

-------------
...half of the truth can be worse than a lie. <----Roger Russell said that..