2000 kia sephia vs python 1400 xp
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=115524
Printed Date: May 02, 2024 at 11:59 PM
Topic: 2000 kia sephia vs python 1400 xp
Posted By: berto1230781
Subject: 2000 kia sephia vs python 1400 xp
Date Posted: August 07, 2009 at 7:10 PM
hey guys i installed this remote start to this car like 3 or 4 years ago and my wife wanted me to add a remote trunk release for it but i lost the instalation manual that it came with can you guys tell me what color wire i have to use from the brain and is the output negative or positive and i'm more likely have to use a relay to convert it and boost the signal right??? in the trunk i'm using just a regular door actuator grounded 1 wire and the other wire is hot please let me know so i can keep the wife happy lol thanks alot
-------------
roberto gonzalez
Replies:
Posted By: mikvot
Date Posted: August 07, 2009 at 7:32 PM
Posted By: Twelvoltz
Date Posted: August 07, 2009 at 7:36 PM
You do need a relay, since you are driving the actuator directly, and your current setup switches hot to release the trunk. The red with white stripe is the low current (200ma) negative channel two output. You would need to convert the low current negative to high current positive. Also, remember that you have to hold the aux button for 2 seconds for it to activate.
-------------
Installer, IT support, and FFL. I need less hobbies.
Posted By: berto1230781
Date Posted: August 07, 2009 at 10:09 PM
Thanks for the help guys tomorrow i will get under the dash and connect the red with white stripe to a relay and from relay to my actuator
-------------
roberto gonzalez
Posted By: berto1230781
Date Posted: August 08, 2009 at 7:34 PM
hey guys 1 more question what size fuse should i use for this install
-------------
roberto gonzalez
Posted By: i am an idiot
Date Posted: August 08, 2009 at 8:26 PM
I would be very surprized if the actuator pulled more than 7.5 amps of current. Try a 7.5 and maybe a 10 if the 7.5 is not holding up. What size wire did you use? ------------- Let's Go Brandon Brown. Congratulations on your first Xfinity Series Win. LGBFJB
Posted By: howie ll
Date Posted: August 09, 2009 at 7:59 AM
RED / white from alarm to 85 on relay, also if required to dashboard switch, other side to ground. 12v+ constant, 7.5 -10amps fused to 30 and 86 on relay. 87 to actuator. 87a not used. Note, I would avise a 1N4004 across 85 and 86 of the relay with the band towards 86. It will protect the alarm's RED / white aux output circuitry.
Posted By: berto1230781
Date Posted: August 10, 2009 at 8:26 PM
i use 14 gaugae from actuator to the front
-------------
roberto gonzalez
|