Print Page | Close Window

xkloader2

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=115806
Printed Date: July 04, 2025 at 5:48 PM


Topic: xkloader2

Posted By: chev104275
Subject: xkloader2
Date Posted: August 21, 2009 at 8:21 AM

does the xkloader 2 need to be plugged into a module to be reconized by the VIP program ?     i tired just the loader to the usb and the program says device not found

-------------
If i Can't Install it    I Don't need it   Joe



Replies:

Posted By: yimke
Date Posted: August 21, 2009 at 10:23 AM
Yes, they all have to be plugged in. Also if it is an optimax module, then it won't recognize it. You have to click optimax flash in the center of the screen.




Posted By: chev104275
Date Posted: August 21, 2009 at 10:58 AM
ok thought so but wasnt sure   ill have to wait till i get a car that needs one to try it out

Thanks Yimke

-------------
If i Can't Install it    I Don't need it   Joe




Posted By: chev104275
Date Posted: August 28, 2009 at 7:01 AM
ok trying to flash a dlpk module using xpressvip. I connect the xkloader2 to the usb and to the module via the D2D cable, run the vip program and click optimax it comes up shows me the firmware that the module has and which module it is also gives me the option for the upgrade. When i click the upgrade and it says ready to flash. I click flash and it tells me the data cable is disconnected (when its not). I have uninstalled and reinstalled everything twice   

Any Ideas ???

Thanks in advance Joe    and sorry for the novel just trying to give as much info as possible

-------------
If i Can't Install it    I Don't need it   Joe




Posted By: kgerry
Date Posted: September 02, 2009 at 5:03 PM

works fine for me... i just grabbed one off the wall and loaded it... when it saw the module under Optimax it said firmware 1.01 and it automatically checked for updates... the updates box said newest firmware was 14.02 and it loaded 14.02 fine......  not a server issue anyway....

i always make sure i have the module plugged into the XKLoader BEFORE i plug the loader into the USB port... may not make a difference but you could try that....



-------------
Kevin Gerry
Certified Electronics Technician
MECP First Class Installer

Owner/Installer
Classic Car Audio
since 1979




Posted By: chev104275
Date Posted: September 02, 2009 at 5:08 PM
thanks i talked with bypasskit.com for about an hour yesterday and i ended up uninstalling everything (drivers too) again. then reinstalled vip 3.1 (had 2.9 before) and it worked i was able to flash the DLPK to version 14.02    thanks for the replys

-------------
If i Can't Install it    I Don't need it   Joe





Print Page | Close Window