pats 2
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=115907
Printed Date: April 28, 2024 at 5:58 PM
Topic: pats 2
Posted By: mike swanson
Subject: pats 2
Date Posted: August 25, 2009 at 5:20 PM
I have a 99 chevy cavalier that the ign has been changed out and the computer has not been relearned to the new ign.
any way around this?
I dont have the old key or ign.
I think this is a bulb test car and i would just have to guess the resistor value.
Replies:
Posted By: Chris Luongo
Date Posted: August 25, 2009 at 11:05 PM
PATS is a Ford system. Your car has either Passlock I or Passlock II.
Anyway, go here:
https://www.the12volt.com/installbay/forum_posts.asp?tid=72296&KW=permanent+passlock+bypass
Go to the fifth post down, and then go to the part that says "5. PROGRAMMING."
Since you don't think your car has a defective Passlock sensor in the ignition switch, just ignore all the stuff about the resistor and the cutting and splicing......just go with the programming first and see if it works.
Posted By: mike swanson
Date Posted: August 26, 2009 at 9:04 AM
yes thank you it is passlock 1. I mutitask to much and this is the result. I type Not what im thinking, but still thanks
the security light just stays on, No blinking
Also i think this car has the bulb test where the black wire from the main ign wires needs to be hooked up
with the sec lite NOT blinking. I think the bcm is bad?
,But yes this is VATS PASSLOCK 1
|