Print Page | Close Window

clifford avant guard 5.5

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=115983
Printed Date: September 18, 2025 at 4:11 AM


Topic: clifford avant guard 5.5

Posted By: rabster
Subject: clifford avant guard 5.5
Date Posted: August 29, 2009 at 2:31 PM

HI i have just had the unit installed to my lexus IS200 Have to say everything works a treat, i also got at the same time the Clifford Callguard CG2.1, i fitted this today although i have wired the following in

12v Feed, Ground feed, Siren Input, armed when ground

i have also wired 3 outputs

so far I can make the outputs work i can send a test message and the unit reports back thats its either armed or unarmed according to the statut of the Alarm, but if i trigger the alarm it does not tell me :(

i have been through the manual and im 99% sure that everything is wired correctly i was told by the installer to take the feed for the siren from the clifford brains Yellow/white Wire in the book it states horn output will this trigger the call guard and allow the warn away feature

OR

Can i wire it to the Clifford 515u siren would this be a better solution ?




Replies:

Posted By: howie ll
Date Posted: August 29, 2009 at 4:30 PM
See other post, I've answered your question, incidentally the installer should have done this. Also hope installer has buried both GPS, and alarm antennae, the GPS antenna is high gain, I've even gone inside the dash on Audis with metal film windscreens with no problems, it's easier on a Lexus, the dash comes out easily.


Print Page | Close Window