factory alarm goes off on remote start

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=116099
Printed Date: July 07, 2025 at 10:38 PM

Topic: factory alarm goes off on remote start

Posted By: corduroy
Subject: factory alarm goes off on remote start
Date Posted: September 04, 2009 at 9:19 AM

So I have this little issue where my standard factory alarm goes off when I remote start the car. Basically, I have yet to hook in the XK01 module to the car. The way I attempted to do it, was incorrect - connecting the data wire of the XK01 to the green plug by the fuse box did not work. Anyone have success completing this? And can you provide a detailed process that a noob can follow?

Thanks.

Replies:

Posted By: corduroy
Date Posted: September 04, 2009 at 9:19 AM

Also this is a Acura TL 2006.

Posted By: KarTuneMan
Date Posted: September 04, 2009 at 12:12 PM

Are these the instructions you followed?

Posted By: tommy...
Date Posted: September 04, 2009 at 7:25 PM

And i think the dis-arm is in the door...So if you dont want to give the XK01 another shot...then its time to take the door off...this is the wire you connected to below this paragraph...?? Also what remote start did you use...Does it have D2D connection...If so, data is the only hard-wire connection...Well trunk pop too...Also on some units...You have to change it too D2D in the programming...Not sure if that applies here...But it might help...!

Acura TL 2006-04... BROWN / Black ...PIN-4, Bottom row of 21-PIN, Green plug, DKP above fuse panel coming in from driver's door

-------------
M.E.C.P & First-Class
Go slow and drink lots of water...Procrastinators' Unite...Tomorrow!