remote start bypass

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=116152
Printed Date: September 12, 2025 at 6:30 PM

Topic: remote start bypass

Posted By: eggie
Subject: remote start bypass
Date Posted: September 07, 2009 at 9:50 AM

I'm firest time installer and I'm installing a RS system on my wife's 2002 Town & Country which is going pretty good until the install of the transponder bypass kit. I have the PKU-CH and I'm trying to wrap the wire 3 to 5 wraps aroung the ignition barrel, but by the time I get to the third wrap, the wiring falls off the end. The problem is that there is only about 1/8" from the end of the barrel to the OEM transponder coil.

Is there a special trick to doing this wrap?

Thanks

-------------
Eggie

Replies:

Posted By: jmsounds
Date Posted: September 07, 2009 at 10:52 AM

there are alot of bypass key transponder that you can get very cheap on the internet you can get the one where the key is put inside a box which is what you are trying to do or the one where you don't need any key but is more wires involve good luck

Posted By: richl68
Date Posted: September 07, 2009 at 10:55 AM

a 556uw comes with a prewrapped transponder ring, just remember that once you wrap it the shroud still needs to fit back on over the key cylinder. The best way to do this is to use a bypass that does not use a key ring type bypass.