Print Page | Close Window

valet 712t driving aftermarket actuators?

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=116153
Printed Date: May 17, 2024 at 4:57 PM


Topic: valet 712t driving aftermarket actuators?

Posted By: nvzack
Subject: valet 712t driving aftermarket actuators?
Date Posted: September 07, 2009 at 10:17 AM

the valet 712t is supposed to be able to drive aftermarket 2 wire door lock actuators with its on board relays but i cant figure out the wiring configuration. particularly the lock and unlock wires from the brain. im using dei 2 wire actuators and need to know which wires go to them and which wires need 12v and/or ground.

-------------
bla bla



Replies:

Posted By: i am an idiot
Date Posted: September 07, 2009 at 10:35 AM
Ground both the BROWN / Black and the WHITE/ Black wires.  Apply constant 12 volts to both the Violet and Violet/Black wires.  Connect the Blue/Black wire to the blue wire of the actuators.  Connect the GREEN/ Black wire to the green wire of the actuators.



Posted By: nvzack
Date Posted: September 07, 2009 at 10:45 AM

the wire colors and labeling from the 712t keyless brain are as follows

GREEN/ black stripe lock #30 common (output)

WHITE/ black stripe lock #87 normally closed

violet/black stripe lock #87 normally open (input)

blue/black stripe unlock #30 common (output)

BROWN / black stripe unlock #87a normally closed

violet unlock #87 normally open (input)



-------------
bla bla



Posted By: nvzack
Date Posted: September 07, 2009 at 11:00 AM

thanks bro. i'll do that



-------------
bla bla


Print Page | Close Window