Print Page | Close Window

valet 712t for 97 altima

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=116166
Printed Date: July 02, 2025 at 8:31 AM


Topic: valet 712t for 97 altima

Posted By: hsmitty99
Subject: valet 712t for 97 altima
Date Posted: September 07, 2009 at 4:00 PM

Hi guys, I'm trying to wire the door lock/unlock remote feature for my daughter's '97 Nissan Altima with factory power locks but no factory remote. I have the factory wiring diagram but I couldn't figure out how to wire the Valet 712T since the instructions are not very useful. Thanks for the help.



Replies:

Posted By: i am an idiot
Date Posted: September 07, 2009 at 5:03 PM

What info do you have for the car?  Positive or negative?  5 wire, reversal???  There is a manual for that alarm on this site.  Just tell me what you can about the car's locking system.

Following is for my info.  So I will know the wire colors.

nvzack wrote:

the wire colors and labeling from the 712t keyless brain are as follows

GREEN/ black stripe lock #30 common (output)

WHITE/ black stripe lock #87 normally closed

violet/black stripe lock #87 normally open (input)

blue/black stripe unlock #30 common (output)

BROWN / black stripe unlock #87a normally closed

violet unlock #87 normally open (input)






Posted By: hsmitty99
Date Posted: September 17, 2009 at 5:31 PM
Thanks a bunch for the quick reply. I travel a lot and only have weekends to work on the car, so I was hoping somebody had already done this installation and could advise me. I'll have to follow the guide on this site to determine which kind of locking system I have and post it.




Posted By: hsmitty99
Date Posted: September 19, 2009 at 2:53 PM
After following the instruction guide on this site, I have discovered the car has a 3 Wire Negative system. Any help from this point is appreciated.




Posted By: i am an idiot
Date Posted: September 19, 2009 at 7:23 PM
GREEN/ black of the alarm to the Blue/Blue wire of the car.
Blue/black of the alarm to the Gray/Red of the car.
Ground the Violet and Violet/Black of the alarm.
Location of the vehicle wires are on the following page.  https://www.the12volt.com/installbay/alarmdetail/1610.html





Print Page | Close Window