rs 04 express van dei xk06

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=116180
Printed Date: July 05, 2025 at 11:14 AM

Topic: rs 04 express van dei xk06

Posted By: easterntg
Subject: rs 04 express van dei xk06
Date Posted: September 07, 2009 at 9:39 PM

I have wired up an alarm with remote start capability. My ignition passlock II wire colors are yellow, tan, and orange with white stripe. The dei instructions are a little vague, can someone tell me which wires I need to connect and where to. The alarm works fine but, I want to get the remote start wired correctly before I test it. Let me know what additional info is needed to respond if any. Thank you.

Replies:

Posted By: easterntg
Date Posted: September 07, 2009 at 10:38 PM

btw, this is a commercial van with no power windows or locks. I just need to figure out how to do the bypass. Does this vehichle use databus??

Posted By: snisen02
Date Posted: September 09, 2009 at 2:47 PM

xk06 will need to be flashed for the plxr firmware - you will use:

brown - status output

red - +12v

black - ground reference in column ( i believe this should be ORANGE / black)

blue - resistance output (yellow in column)

orange - + starter input

pink - + ignition input

Print Page | Close Window